Detailed instructions for using the enema machine

After the impeller, blade and flange of the enema machine are disinfected, they are installed on the enema machine according to the installation sequence. First fix the impeller, and then install the blade opening face down, and then press down the centering flange to restore the hopper, and reset the locking switch.
At this time, there are three working modes that can be switched
(1) Through mode: In the case of choosing through mode, you should press the through confirmation at the bottom of the screen, open the pump, open the filling switch. When the knee touches the knee switch, the material will be discharged. This method is suitable for rectal filling.
(2) Manual mode: When filling, manual mode can output the quantity of materials quantitatively. After confirming manual mode, set according to quantitative. You can set the amount as needed. Turn on the pump and filling switch. Once the knee control switch is touched, the material will be discharged once. Manual working mode can be connected with the twisting machine to complete the twisting process. When connecting with the twisting machine, the twisting system should be connected first, the appropriate filling tube should be installed, the twisting link should be selected and then twisted for confirmation, the servo motor should be started, the number of twisting coils should be selected, the servo motor speed should be adjusted, and the pump and filling signal should be started. At this time, the machine will twist continuously and stop when it is touched again.
(3) Automatic mode: The automatic mode is connected with the punching machine to mutually limit the filling signal. After confirming automatic mode, select the number of grams to be filled. At this time, the appropriate filling pipe is selected to connect with the punching machine, the pump is started and the filling signal is loaded. At this time, the signal from the punching machine will complete a feeding.
Adjustment of punching machine: The punching machine adopts pneumatic punching machine. The card itself is made of aluminum. The upper and lower knives are used to cut the card into a round shape and clamp the shell. The hole punch can only be used when connected to the enema machine. The press screen has a clear prompt button. When the punch key is pressed, one punch can be completed. Do not use empty punch twice in a row, this will damage the punch tool. In the case of pressing single action, the enema filling, punching once, choose linkage, can achieve continuous filling and punching operations.
Notes for use of enema machine:
The enema machine is developed with advanced technology and adopts pneumatic and photoelectric control principle. It can continuously automatically quantify enema systems and medium - grown sausages. The mixer has the advantages of simple operation, convenient maintenance, high precision and good repeatability. Is an effective, easy to operate ideal product, beautiful appearance, compact and reasonable structure, sealed waterproof, easy to clean.
Most enemas are made of stainless steel, durable and fast. Can meet the workload of more than 20 people. There is a micro switch at the entrance, safe operation. For fast slicing, in the case of low precision requirements, flat feed and cutting can be used, which can greatly improve the yield, and different cutter speeds and feed speeds can be used according to different materials.
Enemas come with sharp knives that should be sharpened to keep them sharp when blunted. When the equipment is started, the enema machine should be opened first, and the belt wheel should be synchronized to ensure that there is no foreign matter in the slicing device, before starting the power supply. When rotating parts and high-voltage power supply, first disconnect and lock the power supply during enema maintenance, and then remove the cover plate and protection plate after visually confirming that the equipment has stopped completely. Sausage filling in the cutting site too much accumulation, affecting the cutting efficiency. Do not use abrasive materials, metal tools, iron brushes, or sandpaper to clean any parts. Scrape with a wood or plastic tool if necessary.